Which AP am I connected to & how do I prevent duplicates?

[scaryfruit]

Hi,

Is there a way to tell which AP I'm connected to by using Vistumbler? I know that "usually" it will be the strongest signal, but that's not always a certainty. I think I've found I can use the following netsh command to establish which one I'm connected to: netsh wlan show interfaces. The MAC address of the associated AP is shown on the BSSID line. If this is not currently shown in Vistumbler, could it be added in a later version? Netstumbler showed this by putting an astrix next to the AP which I found to be quite effective.

Also, I've noticed duplicates of the same AP often show up in the view. Is there a way to prevent these?

Thanks for a very useful tool!!!

Kind regards,

Curtis.

[ACalcutt]

Can you show me a screenshot of duplicates being shown? Vistumbler shouldn't make duplicates unless some of the information is different

I don't have any way to indicate what AP is the active one. I will look into a way to mark the connected one