Importing Auto Save Failing?
Posted: Tue May 06, 2014 7:12 pm
I was curious if anyone has had any problems with loading auto saves as I have never been able to load an auto save successfully. It seems like the import process is "bleeding" constantly as it starts off with a high lines/min like 11,000 and then continues bleeding until an unknown speed. I have seen it go as low as 120 lines/min eventually but there is an exponential curve at work as it looks like the higher the lines/min, the faster the bleedout, and the lower the lines/min speed is, the slower the bleeding becomes. Right now I am trying to import a 152,000 line file and the lines/min is decreasing at about four per second running at 2,300 lines/min. This bleeding leads to the time continually going up as well so what starts at 25 minutes ends up going for over 1,000+ minutes.
I have left this running for around 24 hours several times and once it finally gets to about 99.6%, it just stops progressing even though it looks like it is still going. Am I just doing something wrong? I'm basically trying to import the auto save scan data from another computer to continue scanning using that list of access point on another computer. I have tried the import on both v10.5 and v10.5.1 Beta 4 with the same results.
I have left this running for around 24 hours several times and once it finally gets to about 99.6%, it just stops progressing even though it looks like it is still going. Am I just doing something wrong? I'm basically trying to import the auto save scan data from another computer to continue scanning using that list of access point on another computer. I have tried the import on both v10.5 and v10.5.1 Beta 4 with the same results.