I just set up Vistumbler on Windows XP.
It detects the Access Points but they quickly go "dead" on the list and are quickly relisted. So, the list keeps growing filled with 'dead' access points.
I can't get any graphs.
It's pretty useless this way and I haven't figured out what to do about it.
Vistumbler "cycles" through Access Points - No Graphs
- ACalcutt
- Vistumbler / TechIdiots Admin
- Posts: 1302
- Joined: Sun Oct 21, 2007 6:50 pm
- Location: Rutland, MA
- Contact:
Re: Vistumbler "cycles" through Access Points - No Graphs
I will look into this. can you post a screenshot? it shouldnt do what you mentioned, but it may be caused by some recent changes to native wifi mode.
keep in mind that xp really isnt supported by vistumbler. it works, but when scanning APs critical information is unavailbe by the APIs I use and netsh. vistumbler is meant to be used in vista and above.
until i get this fixed you should be able to use v10.3 or 10.2 (im not on a computer right now to check which version). this was before the native wifi changes. I also recommend turning off auto-refresh when using xp.
keep in mind that xp really isnt supported by vistumbler. it works, but when scanning APs critical information is unavailbe by the APIs I use and netsh. vistumbler is meant to be used in vista and above.
until i get this fixed you should be able to use v10.3 or 10.2 (im not on a computer right now to check which version). this was before the native wifi changes. I also recommend turning off auto-refresh when using xp.
- ACalcutt
- Vistumbler / TechIdiots Admin
- Posts: 1302
- Joined: Sun Oct 21, 2007 6:50 pm
- Location: Rutland, MA
- Contact:
Re: Vistumbler "cycles" through Access Points - No Graphs
I release v10.5.1 beta 1 on automatic update. This should fix the issue you were seeing.