Page 1 of 1

how to know the scanning AP was Disconnect

Posted: Thu Jul 07, 2016 1:50 am
by soonlvu
how to know the scanning AP was disconnect ???

how to know the scanning AP was Disconnect

Posted: Fri Jul 08, 2016 9:15 am
by pferland
I'm not sure I understand your question, are you asking how to tell if you are Connected/Disconnected from an Access Point through Vistumbler?

how to know the scanning AP was Disconnect

Posted: Sun Jul 10, 2016 10:55 pm
by soonlvu
pferland wrote:I'm not sure I understand your question, are you asking how to tell if you are Connected/Disconnected from an Access Point through Vistumbler?
yes ...

how to know the scanning AP was Disconnect

Posted: Sat Jul 30, 2016 4:40 pm
by arizonajon
Isn't that "straightforward" to tell by looking at whether the Windows network icon down in the Windows system tray? I don't think Vistumbler is involved in the AP associate/disassociate process, it's Windows driving the process. AFAIK, Vistumbler is just reporting what Windows netsh is hearing.