how to know the scanning AP was Disconnect

soonlvu · Post by **soonlvu** » Thu Jul 07, 2016 1:50 am

how to know the scanning AP was disconnect ???

pferland · Post by **pferland** » Fri Jul 08, 2016 9:15 am

I'm not sure I understand your question, are you asking how to tell if you are Connected/Disconnected from an Access Point through Vistumbler?

soonlvu · Post by **soonlvu** » Sun Jul 10, 2016 10:55 pm

pferland wrote:I'm not sure I understand your question, are you asking how to tell if you are Connected/Disconnected from an Access Point through Vistumbler?

yes ...

arizonajon · Post by **arizonajon** » Sat Jul 30, 2016 4:40 pm

Isn't that "straightforward" to tell by looking at whether the Windows network icon down in the Windows system tray? I don't think Vistumbler is involved in the AP associate/disassociate process, it's Windows driving the process. AFAIK, Vistumbler is just reporting what Windows netsh is hearing.