how to know the scanning AP was Disconnect

Post Reply
soonlvu
Junior Member
Posts: 4
Joined: Tue Jun 21, 2016 10:19 pm

how to know the scanning AP was Disconnect

Post by soonlvu » Thu Jul 07, 2016 1:50 am

how to know the scanning AP was disconnect ???

User avatar
pferland
Contributor
Contributor
Posts: 406
Joined: Mon Oct 22, 2007 8:38 am
Location: The Universe
Contact:

how to know the scanning AP was Disconnect

Post by pferland » Fri Jul 08, 2016 9:15 am

I'm not sure I understand your question, are you asking how to tell if you are Connected/Disconnected from an Access Point through Vistumbler?
The best acceleration you can get on a Mac is 9.8ms^2

soonlvu
Junior Member
Posts: 4
Joined: Tue Jun 21, 2016 10:19 pm

how to know the scanning AP was Disconnect

Post by soonlvu » Sun Jul 10, 2016 10:55 pm

pferland wrote:I'm not sure I understand your question, are you asking how to tell if you are Connected/Disconnected from an Access Point through Vistumbler?
yes ...

arizonajon
Contributor
Contributor
Posts: 219
Joined: Wed Feb 04, 2015 11:17 pm
Contact:

how to know the scanning AP was Disconnect

Post by arizonajon » Sat Jul 30, 2016 4:40 pm

Isn't that "straightforward" to tell by looking at whether the Windows network icon down in the Windows system tray? I don't think Vistumbler is involved in the AP associate/disassociate process, it's Windows driving the process. AFAIK, Vistumbler is just reporting what Windows netsh is hearing.

Post Reply